Setting options of the LUPUS outdoor siren V2 with the LUPUS XT1 PLUS, XT2 PLUS and XT4
# LUPUS outdoor siren V2, settings

Reading time: approx. 2 minutes (for all variants)

You can make three settings:

  • Switch off the tamper contact for one hour (e.g. for installation or battery replacement).
  • Turn the confirmation tone when arming and disarming on or off.
  • Turn the beeps and flash on or off.

The “ Advanced Settings ” of the XT2 (Plus) give you the following setting options:

  • You can adjust the alarm volume.
  • You can set whether the outdoor siren should emit the doorbell signal.
  • You can set whether the siren should also sound an alarm in home mode.
  • You can set whether the siren should sound an alarm in Arm mode.
  • You can turn the siren strobe on or off.
  • You can turn the confirmation flash on or off.
  • You can turn the exit flash on or off.
  • You can turn the entry flash on or off.
  • You can turn the flash trigger function on or off.
  • You can adjust the volume of the exit delay.
  • You can adjust the input delay volume.

Detailed explanations of these options can always be found in the current online manual of the XT2 (Plus)