The wall-mounted SIP RGB Strobe functions as a visual alarm device. The device can be set up as part of a bell group (call group), whereby the strobe is activated as a notification of incoming calls. The SIP RGB Strobe can also be activated by belonging to a multicast group. If audio is recognised on a specific multicast address and a specific port, the strobe is activated.
You can use a web page setting to make the SIP strobe react to waiting messages by flashing. When the message has been heard, the strobe stops flashing.
Multiple colours, flashing rate and brightness can be selected for each of the different activation methods. Users can also use CyberData's HTTP command set to directly access the strobe functions.
Note: Support SIP RGB Strobe with Syn-Apps devices via multicast mode.
- Meets ADA requirements for phone signalling and notification
- Multiple colours, flash rate and brightness can be selected for each of the different activation methods
- Programme or listen to up to 10 multicast addresses
- SIP activation
- Display of waiting mailbox messages
- Multicast activation
- Cisco SRST support
- Event-triggered relay
- Tamper sensor
- Web-based setup
- PoE powered
Manufacurer:
Weight:
Storage:
Benjamin M. Tanner – Managing Director and Security Expert
Do you need individual advice for your project? Do you have any questions about products, project planning or installation? As a managing director with over 18 years of experience in the field of security technology, I would be happy to help you and answer your personal concerns.
- Personal advice
- Trained Expert
- Fast Reply
- 20 years of experience